
Maxseal Flex is a two-component, flexible waterproofing mortar based on synthetic resins and cements, specially formulated to provide waterproofing and protection for concrete and masonry surfaces. It can be applied on the positive or negative side and remains effective even under constant water pressure.
Use in Mérida and Yucatán:
In Mérida and along the Yucatán coast, Maxseal Flex is worth considering for waterproofing walls, slabs and tanks in concrete, block, brick or stone, because it works on both the positive and the negative side. According to its technical bulletin, it goes on in two coats of 1.0 to 1.5 kg/m² each (2.0 to 3.0 kg/m² in total), with at least 12 to 16 hours between coats, and cracks, joints and corners are reinforced with Drizoro Mesh 58. To prevent damage from salt crystallization on the surface, the bulletin calls for an anti-efflorescence treatment such as Maxclear Sulfat. Avoid outdoor application if rain is expected within 24 hours, and keep it moist for at least 24 hours while it cures.
Benefits:
High flexibility, bridges cracks and resists structural movement
Suitable for potable water applications
Excellent adhesion to most building materials
Resistant to weathering, freeze/thaw cycles, and chemical attack
Applications:
Water tanks, pools, basements, retaining walls, facades, roofs, terraces, and areas with water pressure or movement.
Yield and Presentation:
Available in 2 kg and 3 kg applications. Typical coverage: 2-3 kg/m2 total in two coats (varies by surface and exposure).
Warranty:
15 years under proper installation and curing.
Any warranty is valid only with correct installation: surface preparation, mixing, two coats and curing as set out in the technical bulletin. Per the bulletin, consumption and yield vary with site conditions and must be confirmed on the actual job, so ask FORMM for the warranty terms that apply to your project.
Compatibility:
Compatible with Drizoro Mesh 58 and other Drizoro primers and repair mortars.
Application Tips:
Apply on a clean, solid, slightly damp surface. Mix components as directed, and apply in two coats with a brush or trowel.
Warnings:
Do not apply at temperatures below 5C or above 35C. Use gloves and eye protection.
For full technical information or personalized advice, contact us at: materials@formm.mx
Back to Materials
© 2026 FORMM Creative Group